52592

568C V-Blocks and Clamps 52592

Starrett V-Blocks come in a variety of styles to suit the numerous requirements of machinists. They are for general shop use and layout work, as well as for holding stock in place during light-duty milling, drilling, and grinding operations. All clamp screws have a hole to help secure the workpiece. V-Blocks (2) and Clamps (Matched Pair).


Contact Starrett

Features

  • Hardened steel, precision ground parallel and square
  • V-grooves are ground central and parallel to the sides and base - perfect alignment in matched pairs
  • Clamps have screw holes at 45º and 90º to hold either square or round work
  • Stepped groove construction permits high or low clamp mounting or small or large work
  • Clamps do not project over the width of the block, permitting it to be used on the base, ends or sides
  • 3/8-16 tapped holes permit mounting blocks on faceplates or angle irons
  • Each block is 2-1/2" long x 3" wide x 2" high (63 x 75 x 50mm)

Specifications

  • Capacity (in): 2" Dia. Round; 1-7/16" Square (1-9/16" with Screw at Top)
  • Capacity (mm): 50mm Dia. Round; 36mm Square (40mm with Screw at Top)

Product Testimonials

    Write a product review